Im using tftpd32 ( ) and the Chaos Calmer 15.05.1 firmware ( ). To enter the CFE prompt, you can press any key during the boot process, when the countdown stop message appears. Here you can the serial connection pins, on the left the GND, top right RX, bottom right TX). Firmware Modem Alice Gate Voip 2 Wifi Card Serial Connection Pins Summarizing it will be very simple, you just have to connect the router to a RS232 port, set the port at 115200 baud, no parity, 8bits and open your terminal software. The following steps may brick your device, so continue at your risk. ![]() The first step to start the game will be load the OpenWrt firmware. The following steps is needed only if your router hasnt OpenWrt on board. Lets suppose we are serving our main network on 192.168.1.024 ip ranges, and we would like a guest network, isolated from the 192.168.1.024 one, on the 192.168.2.024 ip range. ![]() ![]() This post reports how Ive built a Access Point and a Routed Access Point for a Guest WiFi using OpenWrt. Ive saved three of them from junkyard and I start playing with that devices. OpenWrt is a linux distribution for embedded devices, you can find further information on the openwrt website.
0 Comments
Leave a Reply. |